Updating ios on 6506 sup720

Rated 4.26/5 based on 783 customer reviews

Third, enter the “show module” look for CEF720 modules.

As shown in the card type column, each of these CEF720 line cards will need to have their firmware upgraded.

The firmware is the low level operating system beneath IOS that controls how the various components work and interact.

These are some items that might need to be upgraded in addition to the IOS: Each of the above have their own firmware naming conventions and it can be difficult to find these files.

Always a pain in the backside, isn’t it, when you’re stuck with a router that has no image on it. Format: Drive communication & 1st Sector Write OK... ................................................................................ You’ve listed some IP addresses and Im not sure which is which.

Even if you up the baud rate to 115,200 it still takes an age to download an image over the serial port to the thing. Copying file c1841-advipservicesk9-mz.124-13to flash. program load complete, entry point: 0x8000f000, size: 0xc100 . My Router doesnt have any flash files so I dont have a clue what it’s IP might be.

Format of flash: complete program load complete, entry point: 0x8000f000, size: 0xc100 Initializing ATA monitor library.......There is no formatting of flash per say, but when you perform the steps outlined above, the flash gets prepared and the IOS gets placed on it just fine. WARNING: all existing data in all partitions on flash will be lost! Once I copied the IOS then did “CONFREG 0x2102”, my old startup-config was brought up and all was well… First, copy all the necessary files to the flash on the switch, either to the disk0: or sup-bootflash: or bootflash: depending on what space is available in flash: and verify the md5 checksum of the IOS images.(For purposes here, I copied the files to bootlfash:) Second, backup of the config ().

Leave a Reply